Home → DC100/200 ILT Radiometer Retrofit → Install USB Hub in Enclosure and Connect Cables → USB Hub Installation

5.1. USB Hub Installation

  1. Fasten the DIN rail mounts to the USB hub - P/N here with pic

  2. Find an open section of DIN rail to mount the USB hub

  3. Run +24VDC power (305), DC common (304A) and GND wires from hub terminal to the correct terminal blocks 

  4. Run USB cable that came with hub from the PC to the hub. Label this CBL30009

This page was: Helpful | Not Helpful
Connect USB Cables →