Home → DC100/200 ILT Radiometer Retrofit → Install the New Radiometer and Run Cables → Cable Installation

4.2. Cable Installation

1. Plug new USB cables into ILT1000 – CBL30013 closest to enclosure & CBL30014 closest to radiometer stage (include if only one probe used)

2. Secure cables to radiometer stage carriage

3. Run USB cable ends through arm side of radiometer Igus chain

4. Fasten Igus end to carriage

5. Lay radiometer sensor cables (PXS30220, 30224, 30226) and USB cables (CBL30013, 30014) through the Igus, making sure cables are not twisted inside the Igus chain

6. Re-install Igus chain cover

7. After cover has been fully installed, attach the other Igus end to the radiometer side skin

8. Add a cable tie every 12-18 inches up to the roof skin

9. Run USB cables through the hole in the roof skin

10. Secure cables to the bundle going across the machine to electrical enclosure

    • 

11. Run cables down into electrical enclosure