Home → DC100/200 ILT Radiometer Retrofit → Install the New Radiometer and Run Cables → New Arm Installation

4.1. New Arm Installation

  1. Probe(s) should still be attached to the radiometer arm at this point

  2. Remove radiometer arm from carriage (bolt locations indicated below)

  3. Place old arm on table next to new arm (with ILT1000s already installed) and match left-right positioning of probes – Use stage side of arm as your reference point (pic)

  4. Secure new probes to new arm

  5. Fasten the new arm to the radiometer stage carriage using the same hardware removed in step 2

This page was: Helpful | Not Helpful
Cable Installation →