Home → DC100/200 ILT Radiometer Retrofit → Remove Existing Radiometer and Cabling → Front Panel, HMI, and Top of Machine

3.2. Front Panel, HMI, and Top of Machine

  1. Unplug serial cable from radiometer

  2. Unplug power cable from radiometer (G&R Model 204)

  3. Unplug probe cable(s) from radiometer

  4. Remove radiometer from bracket

  5. Remove battery box (if installed)

  6. Uninstall any brackets for radiometer or battery box and set aside

  7. Pull probe cables, serial cable and power cable through the bulkhead in the front panel

  8. Pull cables through the back of front button panel through the circular opening in the stainless bracket shown below

  9. From above the stacklight, remove probe cables completely

  10. Pull the serial and power cables out the same way

  11. Pull serial/power cables all the way back to the electrical panel, cutting any remaining cable ties as you go

This page was: Helpful | Not Helpful
← Begin Existing Probe Cable Removal Electrical Enclosure →